35×45mm photo preset
Prepare a 35×45mm Photo at 300 DPI
This preset exports a 413×531 pixel JPEG and records 300 DPI in its JFIF density metadata. Converting 35×45mm to pixels at 300 DPI requires rounding to whole pixels, so the physical size is approximate.
Drop an image here
Processing stays local. JPG, PNG, and WebP work best.
The crop frame is locked to the output ratio to avoid stretching. Position your subject inside the frame before exporting; this is a sizing tool, not an official passport-photo certification service.
How to use this page
- Upload a clear photo and position the subject inside the fixed crop frame.
- Check that the required head, neck, and background remain visible, then export the 413×531 JPEG.
- For printing, verify that the print software uses the intended 35×45mm size without automatic fit-to-page scaling. For online uploads, follow the portal pixel and byte requirements instead.
Practical tips
- Check the current destination rules for face size, pose, background, lighting, file size, and acceptable editing. Pixel dimensions alone do not establish compliance.
- Use a sharp original with enough resolution. Enlarging a small crop adds pixels but cannot restore facial detail.
Common questions
Why is the output 413×531 pixels?
At 300 pixels per inch, 35mm converts to about 413.39 pixels and 45mm to about 531.50 pixels. This preset uses 413×531 whole pixels and 300 DPI metadata; print sizing may need a small adjustment.
Does 300 DPI metadata guarantee a compliant passport photo?
No. Density metadata describes a nominal print scale. It does not check the face, background, lighting, or the destination requirements, and some software ignores it.